Influence of FRP Waste on the Properties of Unsaturated Polyester Resin Based Artificial Marble

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户：ZXYCHENLI

【摘要】

：

【作者】

：

Ning Liua Fanggang Liu Guangjin Li Man Zhang Heyi Geb Jianjun Wu

【机构】

：

Shandong Provincial Key Laboratory of Preparation and Measurement of Building Materials, University

【出处】

：

2014中国功能材料科技与产业高层论坛

【发表日期】

：

2014年2期

【关键词】

：

FRP waste Unsaturated polyester resin Artificial marble Mechanical property Cont

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　There is a lot of glass fiber reinforced plastic (FRP) waste every year.Its low utilization rate and serious secondary pollution cause many problems.In this paper, FRP waste was added to enhance unsaturated polyester resin based artificial marble.The effects of FRP waste content and its particle size on the mechanical properties of artificial marble were discussed.

其他文献

基于Zn2SnO4的染料敏化太阳电池研究进展

染料敏化太阳电池以其制备简便、成本低以及效率高等优点受到广泛的关注.目前研究最多的是基于TiO2的染料敏化电池,其最高转化效率已经达到12.3％.作为TiO2的可能代替者,Zn2SnO4因其具有良好的光电性能(Eg=3.6 eV,电子迁移率：10-15 em2V-1s-1)而在染料敏化太阳电池领域受到越来越多的关注.

会议

Zn2SnO4光电转换效率染料敏化太阳电池

High response and selectivity methanol gas sensor using molecular imprinting technique

A new gas sensor with high response and selectivity was fabricated by using molecularly imprinted powders (MIPs) which provide special recognition sites to methanol.

会议

MethanolGas sensorMolecularly imprinted powders (MIPs)

LED用红色荧光粉NaGdTiO4∶Sm3+的合成与发光性能

采用高温固相法制备了白光LED用NaGd(1-x)TiO4∶ xSm3+系列红色荧光粉，并对样品分别进行了X射线衍射分析和荧光光谱测试。研究结果表明，样品可以被390-410的近紫外光有效的激发，在409nm激发下，荧光粉由三个主要发射峰，分别位于567nm、607nm和652 nm处，对应与Sm3+离子的4G5/2→6H52、4G5/2→6H7/2、4G5/2→6H9/2的跃迁发射，其中607n

会议

光致发光红色荧光粉LED固相法

Influence of FRP Residue on the Properties of Epoxy Based Artificial Granite

Nowadays, how to deal with fiber reinforced plastic (FRP) residue becomes very difficult.In this paper, the characteristic of the production technology of epoxy based artificial granite was considered

会议

FRP residueartificial graniteepoxy resinmechanical properties

Synthesis of Mesoporous Silica Microspheres by PICA and Pseudomorphic Transformation Using Silica Fu

Monodisperse mesoporous silica microspheres(MSM-SF) were successfully prepared through PICA and pseudomorphic transformation using silica fume as original silica source.

会议

Silica FumePICA methodPorous Silica MicrospheresPseudomorphic Transformation

The Effect of Saponification Time on the Physical Properties of Mineral Oil-Based Magnetorheological

This overall objective of this work was to investigate the influence of saponification time on the physical property and microstructure of MR greases.With this aim, three mineral oil-based magnetorheo

会议

Magnetorheological GreaseSaponification TimeThermal StabilityPhysical Propert

高疏水聚氨酯泡沫的制备及吸油性能研究

本文通过纳米氧化锌(ZnO)修饰聚氨酯(PU)泡沫和硬脂酸改性ZnO,简便地制备了疏水亲油性质的PU吸油材料,并进行了接触角的表征和吸油性能测试。结果表明,实验制备的ZnO纳米粒子-PU (ZnO NPs-PU)泡沫和ZnO纳米棒-PU泡沫(ZnO NRs-PU)均表现出优良的疏水亲油性能和较强的吸油能力。

会议

纳米氧化锌聚氨酯泡沫疏水性亲油性吸油

刺激响应性静电纺丝纤维及其应用

刺激响应性电纺纤维因其优异的功能成为当前研究的热点。从物理刺激响应和化学刺激响应性能方面，结合纳米纤维的组成，结构，综述了电纺纤维的制备及性能。同时，讨论了刺激响应性电纺纤维在再生医学工程和药物植入释放方面的应用。结合多组分功能化，多刺激响应性的纳米纤维可望成为今后开发的方向。

会议

刺激响应性静电纺丝纳米纤维应用

30CrMnSiNi2A钢连续激光辐照性能变化的微观形貌结构分析

以14.5W/cm2的连续激光辐照30CrMnSiNi2A钢，通过改变激光辐照时间、辐照次数和样品所处环境，获得合金试样的温升历程.用X-射线衍射、扫描电子显微镜、能谱仪和纳米压痕等手段对样品的微观形貌和性能进行表征，发现样品断口均具有氧化膜-脆硬层-基体三层结构特点，脆硬层硬度高于基体，韧性低于基体.

会议

30CrMnSiNi2A钢连续激光辐照效应微观形貌

Ferroelectric and piezoelectric properties of Ba (Ti0.89 Sn0.11)O3thin films prepared by a sol-gel m

We designed a new sort of Pb-free ferroelectric film: Ba (Ti0.89Sn0.11) O3 (BTS) with a chemical constitution at the quasi-quadruple point where the four phases: Cubic, Tetragonal, Orthorhombic, Rhomb

会议

BTS thin filmswater dosageferroelectricitypiezoelectricity

Influence of FRP Waste on the Properties of Unsaturated Polyester Resin Based Artificial Marble

与本文相关的学术论文