高疏水聚氨酯泡沫的制备及吸油性能研究

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户:ylfly5257
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  本文通过纳米氧化锌(ZnO)修饰聚氨酯(PU)泡沫和硬脂酸改性ZnO,简便地制备了疏水亲油性质的PU吸油材料,并进行了接触角的表征和吸油性能测试。结果表明,实验制备的ZnO纳米粒子-PU (ZnO NPs-PU)泡沫和ZnO纳米棒-PU泡沫(ZnO NRs-PU)均表现出优良的疏水亲油性能和较强的吸油能力。
其他文献
Area-selectively liquid-phase-sintering (AS-LPS) method was developed to control the coarsening of Si particles in Al/60vol.% Si composites with the help of sol-gel-derived interfacial modification,ac
A copolymer liquid crystal with a coumarin side group is synthesized and investigated.Under different exposure energy,the thin film of copolymer is irradiated by linearly polarized ultraviolet light (
Graphene oxide (GO) is typically synthesized by graphite powder under strong oxidizing reaction, possessing with the same set of functional groups: epoxy and hydroxyl in basal plane and carboxyl and h
会议
Here a novel technique was employed to fabricated three-dimensionally porous polystyrene (PS)films via ultrasound assisted template method.In contrast to spin-coated thin film, different morphologies
染料敏化太阳电池以其制备简便、成本低以及效率高等优点受到广泛的关注.目前研究最多的是基于TiO2的染料敏化电池,其最高转化效率已经达到12.3%.作为TiO2的可能代替者,Zn2SnO4因其具有良好的光电性能(Eg=3.6 eV,电子迁移率:10-15 em2V-1s-1)而在染料敏化太阳电池领域受到越来越多的关注.
A new gas sensor with high response and selectivity was fabricated by using molecularly imprinted powders (MIPs) which provide special recognition sites to methanol.
采用高温固相法制备了白光LED用NaGd(1-x)TiO4∶ xSm3+系列红色荧光粉,并对样品分别进行了X射线衍射分析和荧光光谱测试。研究结果表明,样品可以被390-410的近紫外光有效的激发,在409nm激发下,荧光粉由三个主要发射峰,分别位于567nm、607nm和652 nm处,对应与Sm3+离子的4G5/2→6H52、4G5/2→6H7/2、4G5/2→6H9/2的跃迁发射,其中607n
Nowadays, how to deal with fiber reinforced plastic (FRP) residue becomes very difficult.In this paper, the characteristic of the production technology of epoxy based artificial granite was considered
Monodisperse mesoporous silica microspheres(MSM-SF) were successfully prepared through PICA and pseudomorphic transformation using silica fume as original silica source.
This overall objective of this work was to investigate the influence of saponification time on the physical property and microstructure of MR greases.With this aim, three mineral oil-based magnetorheo