论文部分内容阅读
金属零件的炉中钎焊,必须先在焊剂溶液池中清洗后,才能入炉钎焊。一般链轨式钎焊炉前装有较复杂的机械装置来完成这一工艺过程。由于链轨在零件加热时同时受热,会带走大量的热量,从而消耗大量的电能。延长工件在炉中的加热时间,链轮、链板与链轴都需要采用耐热钢制造,针对这些缺点,我们研究并制造成利用炉门升降动作自动完成清洗工艺的滑台式自动钎焊炉,效果很好,介绍如下: 一、结构原理钎焊炉中吊篮3与炉门7、16被钢丝绳6、10
Metal parts of the furnace brazing, must first be cleaned in the flux solution pool before brazing into the furnace. General chain-track brazing furnace equipped with more sophisticated mechanical devices to complete this process. As the rail heating at the same time when the parts are heated, will take away a lot of heat, thus consuming a lot of electricity. To prolong the heating time of the workpiece in the furnace, the sprocket, the chain plate and the chain shaft need to be made of heat-resistant steel. In response to these shortcomings, we research and manufacture a sliding table type automatic brazing furnace that automatically performs the cleaning process by using a door lifting action , The effect is very good, introduced as follows: First, the structural principle Brazing furnace basket 3 and the door 7,16 by the rope 6,10