【摘 要】
：
The movement pattern of ellipsoidal nanoparticles confined between copper surfaces was examined using a theoretical model and molecular dynamics simulation. Initially, we developed a theoretical model of movement patterns for hard ellipsoidal nanoparticle
【机 构】
：
State Key Laboratory for Mechanical Behavior of Materials,Xi’an Jiaotong University,Xi’an 710049,Chi
论文部分内容阅读
The movement pattern of ellipsoidal nanoparticles confined between copper surfaces was examined using a theoretical model and molecular dynamics simulation. Initially, we developed a theoretical model of movement patterns for hard ellipsoidal nanoparticles. Subsequently, the simulation indicated that there are critical values for increasing the axial ratio, driving velocity of the contact surface, and lowering normal loads (i.e., 0.83, 15 m/s, and 100 nN under the respective conditions), which in turn change the movement pattern of nanoparticles from sliding to rolling. Based on the comparison between the ratio of arm of force (e/h) and coefficient of friction (μ), the theoretical model was in good agreement with the simulations and accurately predicted the movement pattern of ellipsoidal nanoparticles. The sliding of the ellipsoidal nanoparticles led to severe surface damage. However, rolling separated the contact surfaces and thereby reduced friction and wear.
其他文献
The tribological characteristics of cotton fibers play an important role in engineering and materials science, and real contact behavior is a significant aspect in the friction behavior of cotton fibers. In this study, the tribological characteristics of
A macroscopically nominal flat surface is rough at the nanoscale level and consists of nanoasperities. Therefore, the frictional properties of the macroscale-level rough surface are determined by the mechanical behaviors of nanoasperity contact pairs unde
Understanding asperity flattening is vital for a reliable macro-scale modeling of friction and wear. In sheet metal forming processes, sheet surface asperities are deformed due to contact forces between the tools and the workpiece. In addition, as the she
The tribological behaviors of Ti–Ni51.5 at％ alloy strengthened by finely dispersed Ni4Ti3 particles in reciprocating sliding against GCr15, Al2O3, and ZrO2 at room temperature were studied. Interestingly, the coefficient of friction (COF) suffered a sheer
Alloys used as bearings in aircraft landing gear are required to reduce friction and wear as well as improve the load-carrying capability due to the increased aircraft weights. Cu–15Ni–8Sn–0.8Nb alloy is well known for possessing good mechanical and wear
Aluminium alloys are commonly used as lightweight materials in the automotive industry. This non-ferrous family of metallic alloys offers a high versatility of properties and designs. To reduce weight and improve safety, high strength-to-weight ratio allo
Sub-surface crack networks in areas of altered microstructure are a common cause for bearing failures. Due to its appearance under light microscopy, the damage pattern is referred to as White Etching Cracks (WEC). The root causes leading to the formation
Thickener formulation plays a significant role in the performance characteristics of grease. The polyurea greases (PUGs) were synthesized using mineral oil (500SN) as the base oil, and by regulating the reaction of diphenylmethane diisocyanate (MDI) and d
The microstructure, mechanical and micro/nano-tribological properties of the 60NiTi film annealed at different temperature were investigated. The results reveal that annealing as-deposited 60NiTi film at 300, 375, and 600 ℃ for 1 h leads to structural rel
In the glass molding process, the sticking reaction and fatigue wear between the glass and mold hinder the service life and functional application of the mold at the elevated temperature. To improve the chemical inertness and anti-friction properties of t