论文部分内容阅读
我们拉制漆包线用圆铜线的φ8毫米铜杆,都要采用附图所示的剥皮模进行剥皮。对剥皮模的修制,以往我们都是采用手工操作,在校正和固定模具中心后,用油石和碳化硼研磨各加工部位,因而修制成的剥皮模的前后角大小不一,同心度差,平行管有偏斜现象,平行管长度和排屑槽深度误差较大,工作角难以控制准确。用手工修制的模具将铜杆剥皮时,经常出现剥皮单边、断头、剥皮杆表面不光洁等弊病,而且每只剥皮模的平均寿
We pull the enameled wire with φ8 mm copper wire round copper wire, are used to peel the skinning model shown in the figure. The skinning mold repair, in the past we are using manual operation, after the center of the mold and fix the mold, with whetstone and boron carbide grinding the processing parts, and thus repair the peeling mold before and after the corner of different sizes, concentricity difference , The parallel pipe has a skew phenomenon, the parallel pipe length and the flute depth error are large, and the working angle is difficult to control accurately. Hand-made mold will be copper rod peeling, often peeled unilateral, broken head, peeling rod surface is not smooth and other ills, but also the average life of each peeling mode