我厂制成一种快速装夹木模用虎钳,实践证明,操作简单,使用方便,装夹迅速。如图1所示,固定钳座2用四个螺栓11紧固在钳桌1上,偏口螺母6(图2)和偏重套简7(图3)用销子8联接,偏重套简7套在丝杠5上。装夹工件时,先将丝杠5拉开,将工件放入,推动活动钳座4以夹住工件,顺时针摇动手轮10。由于偏重套筒的自重作用,使其两端的φ24孔压在丝杠上, I plant a quick clamping wood vices, practice proved that simple operation, easy to use, rapid installation. As shown in FIG. 1, the fixed clamp base 2 is fastened on the clamp table 1 by four bolts 11, the partial split nut 6 (FIG. 2) and the partial heavy sleeve 7 (FIG. 3) are connected by the pin 8, Set on the screw 5. When clamping the workpiece, first pull the screw 5, put the workpiece into it, push the movable clamp base 4 to clamp the workpiece, and shake the handwheel 10 clockwise. Due to the self-weight of the role of emphasis on the sleeve, so that both ends of the φ24 hole pressure on the screw,