水润滑橡胶导轴承,具有结构简单,吸振性好,造价廉等优点,因此它被广泛地应用在小型水电站中。传统的这种轴承,是将铸好的橡胶瓦筒一分为二,镶在固定套内,然后再将固定套固定在水轮机上压盖上,待运行磨损后(间隙过大)将橡胶瓦整体更换,换瓦时非常麻烦,遇到含砂量较高的电站,几乎是每2至3个月就得更换1次,这对机组的稳定 Water-lubricated rubber bearing, with simple structure, good vibration absorption, low cost, etc. Therefore, it is widely used in small hydropower stations. The traditional bearing of this kind is to divide the cast rubber tube into two parts and insert it into the fixing sleeve, then fasten the fixing sleeve to the pressure cap of the turbine. After the running wear (the gap is too large), the rubber bush The overall replacement, when the tile is very troublesome, encountered high sand power plant, almost every 2 to 3 months have to be replaced once, which is the stability of the unit