由高压水泵站通过高压水管路系统供应锻造水压机的高压水,流速较高。在水压机进行各种操作时,要求的水量和水流方向也在不断变化。因此,用来支承阀门和固定高压水管路系统的支架,受力状态就比较复杂。过去,我们曾把高压阀门与管道支架当作一般动力管道支架来设计,采用悬臂梁式。这种形式的支架,在高压水的变动载荷作用下,很快就产生松动、倾斜和损坏。后来,将支架设计成图a High-pressure water pumping station supplies high-pressure water forging hydraulic press through high-pressure water pipe system, high flow rate. In the hydraulic press for various operations, the required amount of water and water flow direction is also changing. Therefore, the support used to support the valve and fixed high-pressure water piping system, the stress state is more complicated. In the past, we used to design high pressure valves and pipe supports as general power pipe supports, using cantilever beams. This form of bracket, in the fluctuating load of high-pressure water, quickly produce looseness, tilt and damage. Later, the stent design diagram a