论文部分内容阅读
为了使插秧机手迅速掌握小苗部件的使用技术,发挥插秧机在春插时应有的作用,本文着重介绍一下广西65—2型插秧机小苗部件的使用技术(有关图请看本期第6页“广西65—2型插秧机小苗部件”一文)。使用前一、检查 1.要求六个秧爪尖伸进秧箱距离一致,与秧箱防护板同时接触,并有适当的切压力。 2.六个秧爪上下摆动时,秧爪外侧与固定秧夹内侧间隙在0.2~1毫米之间。 3.各个秧爪的中爪与脱秧片(图1)前端应有1~3毫米的间隙,两者在正中位置。 4.秧爪尖在秧箱防护板上抬
In order to make the transplanter quickly grasp the use of seedlings parts technology, play the role of transplanter should be inserted in the spring, this article focuses on Guangxi 65-2 transplanter seedlings parts technology (see Figure 6 Page “Guangxi 65-2 transplanter seedlings ” article). Use the previous one, check 1. Require six seedling claw tip into the same distance from the box, and seedling box protection board at the same time contact, and the appropriate cutting pressure. 2. When the six seedlings swing up and down, the lateral and the fixed seedling clamp seedling medial gap between 0.2 to 1 mm. 3. Each claw claw claw and reborn film (Figure 1) the front should be 1 to 3 mm gap, both in the middle position. 4. Seedling tip sharp in the seedling box protection board elevation