试验条件和方法将已用始温为85℃的水浸泡24小时的Ⅲ级刺槐种子放入方形有机玻璃容器中(容器规格:长、宽、高分别为40cm、25cm 和30cm),加水将种淹没;再把用白铁皮做的两块方形电极板(长20cm、宽10cm)平行地竖放在容器内两端,每块电极板上各接一根导线,其中一根导线上串联一只电流表(试验时测量电流强度用);最后接通电源(交流220V,50Hz).本次试验电流强度为15mA,水温20±5℃.处理时间分别为10、20、30、40、50min 和对照,每个处理分 Test conditions and methods The seeds of Class III locusts that had been soaked in water for 24 hours at a temperature of 85 ° C were put in a square plexiglass container (container size: 40 cm, 25 cm and 30 cm in length, width and height, respectively) Submerged; and then made of white metal plate made of two square (length 20cm, width 10cm) parallel to the container at both ends of the vertical, each electrode plate connected to a wire, one of the wires in series with a Ammeter (test current intensity used); last power (AC 220V, 50Hz) .This test current intensity is 15mA, water temperature 20 ± 5 ℃ .Processing time were 10,20,30,40,50min and control , Each processing points