论文部分内容阅读
一、前言普型冲压可拆链工字钢轨道的悬挂输送机,已普遍的用在屠宰、冷库的输送及搬运工序。该机的推式及悬式两种结构形式的负载计算,在肉类工业(82.7期)已作过介绍。轻型封闭轨悬挂输送机,包括单个吊点负载为30、50公斤两种,目前在食品厂的包装输送及猪头烫毛工序,都已采用。因此,有必要作一介绍。本文介绍的是概略计算法。对于总长不超过200米,全部水平和垂直转弯折算成90°,转弯数量不超过20个的单驱动输送机,一般只需用概略计算。二、总负载计算的目的总负荷及线路计算,亦称工艺设计,又称线路设计。欲使用输送机,首先要进行工艺线路设计,因为通过设计之后,才能知道所选用的输送机的型号是否正确;并知道该线路所需
First, the introduction of general-purpose stamping detachable chain I-track suspension conveyor, has been commonly used in slaughtering, cold storage transport and handling processes. The aircraft’s push and suspension structure of the two load calculation, in the meat industry (82.7) has been introduced. Lightweight closed rail suspended conveyor, including a single load point of 30,50 kg load two, the current packaging in the food factory and pig hair scalding process, have been used. Therefore, it is necessary to make an introduction. This article describes the approximate calculation method. For single-drive conveyors with a total length of not more than 200 meters, all horizontal and vertical turns converted to 90 °, and the number of turns not exceeding 20, a general calculation is only required. Second, the total load calculation The purpose of total load and line calculation, also known as process design, also known as line design. To use the conveyor, you must first design the process line, because after the design, you can know the model of the selected conveyor is correct; and know the required line